LEGEND® II INSTALLATION MANUAL
IV. TROUBLESHOOTING AND PERFORMANCE TIPS
A. PROBLEMS & SOLUTIONS - (cont.)
Problem: Sweep Hose is sucked into the cleaner.
Solution: 1. Adjust the Sweep Hose using the
Adjustment Screw located on the
bottom of the Swivel Mast. Turn
Adjustment Screw clockwise until the
Sweep Hose is in a gentle sweeping
motion.
Problem: Sweep Hose breaks surface and sprays
nearby windows, patio decks and
bystanders.
Solution: 1. Adjust Sweep Hose to a gentle
sweeping motion.
11
1. Tips on Hose Cutting for Larger Pools.
If the hose is short of the farthest end of the pool,
add an additional section of hose (Part # LX17/
360020), one Swivel (Part # LX19/360023), two
Mender Nuts w/O-Rings (Part # LX20/360022),
and one Hose Float (Part # LXD10/360019). See
diagram below. Re-measure and follow guides on
pages 3-4
.
TIPS FOR CUTTING HOSE IN A SMALL POOL,
AND FOR ADDING HOSES FOR LARGE POOLS
1. Tips on Hose Cutting for Smaller Pools.
If the hose hangs over the deck more than 9 ft. or the
pool is less than 6 ft. deep and narrow, cut 36 in. off
the 5 ft. section hose at the end of the feed hose and
remove one float. Then remove one 6 ft. hose (see
diagram), 1 swivel and 2 mender nuts. Re-measure
and cut hose according to the guides on
pages 3-4
.
Pressure Tester
Back-Up Valve
ADD IN HOSE LENGTHS AS NEEDED.
REMOVE ONE LENGTH FOR SMALLER POOLS.
8"
Float
Swivel
Mender Nut
Mender
Nut
Wall Fitting
15"
2' Hose
6' Hose
6' Hose
15"
15"
6' Hose
15"
15"
5' Hose
15"
18"
Hose
15"
6' Hose