3
T
OT
AL
DYNAM
C HEAD-FEET
CAPACITY-U.S. G.P.M.
0
24
48
72
96
120
144
0
8
16
24
32
6/10 HP
SK60 Performance Curve
Pump
Servicing
Read the following instructions
carefully before replacing any
parts. Reasonable care and safe
methods should be practiced.
Check local codes and
requirements before installation.
Only a competent electrician
should make the installations.
The following steps should be
performed by an authorized
service center.
Important: Read all directions
before replacing any parts.
Remove pump and switch from
power source before servicing.
1.
Replacing diaphragm switch.
From switch housing (9)
remove screw (8) from housing.
Replace with new switch.
Insert screw (8) into housing
(9) and tighten. Plug pump
into switch and switch into
correct power source.
2.
Replacing wide angle switch.
From motor housing (21)
remove switch tethering screw
(29). Replace with new switch
(27) with new switch tethering
screw (29). Plug pump into
switch and switch into correct
power source.
Note: To be sure wires are
not burned or broken in cord,
use ohmmeter for check. Set
ohmmeter scale pointer to R 2 1
scale and attach one meter lead
to white cord wire and one
meter lead to black cord lead.
Place screwdriver blade across
blade terminals of plug (1). If
cord is functional, the meter will
go to zero (0). If open (
∞
), cord
must be replaced.
