Pentair Pool Products E-Z Vac, Инструкция по установке и эксплуатации

Страница: 5 / 15

5
NOTE: One section is fitted with two female ends. See Figure 5. Attach this section last.
Begin by attaching the female end of a male/female hose section to the swivel head of your E-Z Vac.
See Figure 6. Connect two more male/female hose sections to the first section. Then install the hose
weight near the male end of the third hose section as shown in Figure 6. Finally, assemble the complete
hose, ending with the female/female section. To ease the assembly of the hose dampen the hose
ends with water as you assemble them together.
IV. Installation
Standard Installation
1. IMPORTANT: Turn the pool pump off before
proceeding with this step. Make sure all other
suction lines, including the main drain (if your pool
has a main drain), are closed – EXCEPT for the
suction line from the skimmer.
2. Remove the skimmer basket and fit the valve cone
down into the suction line located in the bottom of
the skimmer. Press down until snug.
3. Press the automatic regulator valve down into the
valve cone until snug. See Figure 7. (The end of the
valve that is marked “attach hose this end” must point up.)
Figure 7
Top of Skimmer
Hose through
Skimmer Opening
Automatic
Regulator Valve
Valve Cone
Attach
Hose
this end
Figure 6
Hose Weight
Swivel Head
Female End of a
Male/Female Section
(Your fully assembled E-Z Vac should look like this.)
Note: The hose length illustrated is not
representative of actual size. You may
need to use more sections than shown.