Pentair Pool Products E-Z Vac, Инструкция по установке и эксплуатации

Страница: 11 / 15

11
TO REMOVE DEBRIS FROM THE FLAPPER
• Sometimes debris may clog the bottom of the cleaner and prevent flapper movement or
restrict flow. The flapper is located inside the main body and must move freely at all times.
• You can see the flapper through the opening in the baffle plate, when you turn the cleaner
upside down as shown in Figure 12. Jiggle
the flapper with your finger or flush the
cavity with a hose to force out any debris
lodged inside the main body.
• If debris is still lodged inside, you must
remove the flapper. First, lift the lip of the
foot pad up and insert a flat-headed
screwdriver along side one of the two tabs
found on either side of the baffle plate. See
Figure 13. Push the tab inward with the
screwdriver until the baffle plate releases.
Place a finger into the center opening of the
baffle plate and pull up until it pops out.
Then pull the flapper out. NOTE: You
should be able to do this without taking
the foot pad off.
• Once the debris is dislodged, insert the flapper back into the main body and snap the baffle plate
back into position. Be sure that it is securely in place. See Figure 13.
Figure 13
Foot Pad
(not necessary to remove)
Baffle Plate
Flapper Main Body
Figure 12
BOTTOM VIEW OF CLEANER
Foot Pad
Flapper is
inside
Baffle Plate
Aboveground
Seal