.While not required, you may elect to install the wheel kit that is included
with your generator. To do this, follow the instructions below:
1. On a level surface, elevate your generator
’
s cage on wood or cement
blocks to make it easier to assemble your wheel kit.
2. Attach the support leg to the cage using the cap screws and lock nuts
provided (See Figure aa).
3. Attach the axle to the cage using the cap screws and lock nuts provided
(See Figure bb).
4. Place
(See Figure cc,
Figure dd, Figure ee).
Make sure the wheel
’
s air valve is
accessible. Install the wheel with the valve facing out.
5. Attach the handles to the cage using the cap screws and lock nuts
provided (See Figure ff, Figure gg).
6. Double check that all screws, lock nuts and pins are secure.
Note:
a wheel over the axle, then slide a flat washer over the axle.
Tighten down the wheel with the retaining pin provided
GENERATOR WHEEL KIT ASSEMBLY
Copyright 2010 DTX International
8
Note: Inflate your tires to between 15-30 PSI
Figure aa
Figure bb
Figure cc
Figure dd
Figure ee
Figure ff
Figure gg
