GENERATOR COMPONENTS AND PACKAGE CONTENTS
Copyright 2010 DTX International
The following tools should be included in your generator package:
(1) Phillips-head screwdriver (A)
(1) Hex-head wrench (B)
(1) Spark plug wrench (C)
7
COMPONENTS
Before operating your generator, be sure to
become familiar with all usage instructions and
the components listed below:
1. Air cleaner-
2. Choke lever-
3. Fuel gauge-
4. Fuel cap-
5.
6.
7. Voltage Selector
8.
can be removed and cleaned to help keep
your generator running at peak efficiency by preventing dirt
from getting in to the engine.
Regulates engine air intake.
Gasoline level indicator.
Fuel tank cap.
-switch between 120V only and
120V/240V.
Voltage meter-
120 Volt AC receptacle-
120/ 240 Volt AC receptacle-
9. Circuit breaker
10.Ground terminal-
11. Idle Control Switch-
12. 12V DC batteries.
13. l2V DC receptacle-
Reads current voltage output.
Use to connect electrical
devices that run 120 Volt, 60 Hz, single phase, AC current
(2
¡Á
duplex GFCI).
Receptacle to connect
electrical devices running 120/240 Volt, 60Hz, single phase,
AC current (NEMA L14-30).
- Reset switch protecting generator from
overload.
Grounding wires connection point to
ensure proper grounding of generator.
Idle control will allow fuel savings
when ON (use when there is no load on generator), when
devices are attached leave in OFF position.
Receptacle only for charging 12
Volt automotive-type batteries.
14. Oil filler cap-
Oil fill and dipstick-
Recoil starter-
Fuel filter cup-
Fuel valve-
Spark
plug-
Muffler- Quiets engine.
Access for checking oil levels and
adding oil.
Location for checking and filling
engine oil.
Pull-cord for starting engine.
Filters fuel.
Controls flow of fuel to engine.
Necessary for engine ignition.
21.
15.
Engine Switch
16.
17.
18.
19.
A
B
C
