Ultra1000 Wireless Detectors
(Battery Operated)
Rev 2
Page 11
3.
To change the address, select
Set Address
from the options by holding the magnetic
wand to the junction box at 4 o’clock position.
4.
After few seconds the current Address will be displayed. Hold the magnet to change the
address ( 1 unit at a time). The maximum address limit is 64. The address rolls over to 1 after
reaching the limit. Move the magnetic wand away once the desired address is displayed on
the LCD. The address is now saved into memory.
5.
The sensor will go back to scroll the Config options. Select the
Set Zone ID
from the
options by holding the magnetic wand to the junction box at 4 o’clock position.
6.
To change the Zone ID hold the magnet until desired zone id is displayed on the LCD and
then move the magnet away.
7.
Few seconds after the magnet is removed, the unit will save the zone ID and then return
back to the Config Options.
Note:
Network / Zone ID should be set to 0 unless multiple Controllers / Gateways are used within
the transmitting range of each other. The default Zone ID is 0 for all the gateways,
controllers and sensors shipped from the factory.
Magnet tool to activate
Internal switch
Figure 3.
Edit Config Mode
. Setting Unit Address & Zone ID
