Pelsue PH Series, Руководство по эксплуатации продукта

Страница: 17 / 36

501144-001 - Product Manual - PH Series Personnel Hoists - Revison 03 Revision Date - 2018-06-13
Page 17
Figure 5j : PH Series Hoist
Removal
HOIST
HANDLE
5.5 - Field Operation (continued)
iv) Refer to applicable manuals for detailed instruction on threading the hoist line through pulleys and rollers
on the support structure and/or guide blocks (fairleads).
v)
Be sure the hoist line crimps, thimble, swivel and snap-lock connectors are in good condition and
functioning as intended. See Figure 5f.
vi) Attach the snap hook to the entrant’s full body harness. See Figure 5h.
Figure 5f Figure 5g
Figure 5h
DETENT
PIN
Figure 5i : PH Series Hoist
Detent Pin
b. lifeline retraction
i) When entrant is clear of the confined space and properly supported, disconnect the snap hook from harness.
Maintain at least a 10 lb.(4.5kg.) load on the hoist line in order to maintain a neat and tight line coil on the
drum.
ii) Remove the hoist line from all pulleys and rollers on structure. (Refer to applicable manual).
iii) Turn the drive handle to retract the line while maintaining a 10 lb.(4.5 kg.) tension on the line.
iv)
Retract until the crimps and thimble just touch the drum.
CAUTION: Winding the hoist line too far could cause damage to the hoist as the snap becomes
entangled with the hoist tensioner system. Damage to the line may also result, affecting the
strength of the hoist line.
c. Hoist removal from Support Structure
i) Remove the detent pin. See Figure 5i.
ii) Grasp the hoist handle and pull the top of the hoist away from the structure while lifting upwards to unhook
the slots of the quick release bracket from the anchoring rod on the mounting bracket. See Figure 5j. Store
as required.
Note:
For further storage, the drive
handle can be removed from the
hoist chassis by pulling on the ring
of the spring plunger. See Figure 5k
Figure 5k : PH Series Hoist
Drive Handle Removal
SPRING
PLUNGER