PelPro Pellet Stove • 8104-171B • 10/21
PelPro Pellet Stove • 8104-171B • 10/21
24
25
Replacement Parts
Maintaining
Your
Stove
Having Trouble?
Visit the Troubleshooting section of
this manual.
Maintaining Your Stove
Electrical Components
• Identify and remove any debris
• Verify all connections are secure
Exhaust Blower
• Remove left side panel to access and remove exhaust
blower
• Vacuum any debris from the fan blades and blower housing
Zone 3 - Venting
Termination Cap
• Remove termination cap
• Brush out to remove dust and hard buildup
Vent Components
•
Soot, creosote, and fly ash will collect in the exhaust
venting system and restrict the flow of the flue gases.
This build up will occur more quickly in horizontal
sections and elbows.
• Use the appropriate sized chimney brush to remove ash
and buildup from the venting
Outside Air Kit
• Ensure there are no obstructions in the outside air kit
cap
ANNUALLY
AS NEEDED
OR
ANNUALLY
AS NEEDED
OR
Caution!
When wood pellets are burned at a low temperature, they produces organic vapors which combine with moisture
to form creosote vapors.
Creosote vapors condense in the relatively cool chimney flue of a newly-started or a low-temperature fire. As a
result, creosote residue accumulates on the flue lining. When more heat is called for, this residue can be ignited,
which creates an extremely hot fire in the chimney flue; this may damage the chimney or even destroy your home.
Your chimney should be inspected once every few months during the heating season to determine if a creosote
or soot buildup has occurred. If creosote or soot has accumulated, it should be removed to reduce the risk of
a chimney fire.
1
Zone
1
Zone
3
Zone
3
Zone
2
Zone
2
Zone
Replacement Parts
Replacement part for your Stove
Visit
1
Zone
1
Zone
2
Zone
2
Zone
3
Zone
3
Zone
1
Zone
1
Zone
2
Zone
2
Zone
3
Zone
3
Zone
Glass
1.
Open the door from the appliance by lifting door off of
hinge pins and lay on a flat surface face down.
2. Using a Phillips head screwdriver, remove the 3
brackets and set aside.
3. Remove old glass and gasket from door.
4. Replace gasket to door and add glass.
5. Re-install the brackets using the same screws.
Glass replacement kit: SRV7081-173
Door assembly replacement kit: SRV7086-021
Baffles
1.
Turn the dial control to the off position. Make sure
the unit is cool.
2.
Remove the center baffle first by using the handle
at the top of the baffle and pull up and then towards
you. The hooks on the baffle will slide out of the slots
in the bracket.
3.
Remove the left baffle and then the right baffle by
pulling up and then towards you. The left and right
baffles have similar hooks and slots.
Replacement kit: SRV7077-006
Zone 1 - Front of Stove
Zone 2 - Firebox
WARNING!
Glass is 5mm thick high temperature heat resistant ceramic glass.
•
DO NOT REPLACE with any other material
•
Alternate material may shatter and cause injury
