pela tools 498189, Руководство пользователя

Страница: 14 / 24

WARNING! NEVER CLIMB
THE MACHINE.
Serious damage can occur
if the machine tilts or if the
saw blade is touched by
mistake.
WARNING! ALWAYS
CHECK FOR DAMAGED
PARTS. Before using the
machine, the guard and
other parts should be
checked to make sure they
are working properly and
performing the intended function.
Check that the moving parts are adapted, the
brackets for moving parts are intact, and there are
no cracks on the parts, assembly and any other
conditions that may affect its operation. A cover or
other damaged parts must be repaired or replaced
immediately.
Special safety instructions for band saws
Always stop the band saw before removing wood
debris from the table. Always keep your fingers
away from the blade. Never try to saw workpieces
that do not have a flat surface, unless suitable
support is used. Always hold the material firmly
and feed it into the blade at a moderate speed.
Always switch off the machine if the material is to
be backed out of an incomplete cut. Adjust the
upper guide approx. 0.3 cm above the material
being cut. Check that it is the right size and type of
saw blade for the material to be sawn. Make sure
the blade tension and tracking are set correctly.
Make lighter cuts before sawing long contours.
Release the blade tension when the saw will not be
used for a long time.
User liability / guarantee
This machine will perform as described in the
instructions. This machine must be checked
regularly. Defective equipment (including power
cord) should not be used. Parts that are damaged,
missing, obviously worn, distorted or contaminated
should be replaced immediately. If such repair or
replacement becomes necessary, it is
recommended that only genuine spare parts be
used and that such repairs be carried out by
qualified persons. This machine or any of its parts
may not be modified or modified from the standard
specifications. The user of this machine shall be
solely responsible for any faults that occur due to
improper use or unauthorized modification from
standard specifications, improper maintenance,
damage or improper repair by anyone other than a
qualified person.
Model MJ345N
Max saw depth 465 mm
Length of saw blade 3405 mm
Width of saw blade 6-30 mm
Slope saw blade 0 ~ 45°
Max saw height 285 mm
The size of the saw table 535 x 485 mm
Saw blade speed 9 m/s,14 m/s
Engine 2,2 kW