PEKO ETS-1500, Инструкция по установке и эксплуатации

Страница: 5 / 16

Installation and Operating Manual
Page 5
INSTALLATION INSTRUCTIONS (cont.)
REVERSING THE DOOR HINGE SIDE
The door is supplied as standard with the hinges to the right hand side.
Follow the instructions below to change to left hand side hinge .
1. Place the packaging material on the floor for protection then lay the cabinet down with
the door uppermost.
2. Remove the four screws that secure the upper service module (1) and carefully with-
draw the unit from the cabinet. The screws (2) can be accessed from the inside top
panel of the cabinet.
3. Remove the upper hinge pin (3) and lift off the door.
4. Remove the lower hinge pin (5)with a flat blade screwdriver(4). This can be achieved
without removing the lower control module(6).
5. Remove the lower white plastic guide plug on the unused hinge bracket and refit to the
opposite side.
6. Refit the lower hinge pin to the opposite side.
7. Reverse the door by turning it through 180°.
8. Refit the the upper hinge pin.
9. Refit the upper controle module with the four screws.
10. Remove the pivot pin from the lower hinge and lift off the door.
11. Unscrew the pivot pin from the upper hinge and re-fix to the opposite side.
12. Turn the door upside down and locate into the upper hinge pin; position door on lower
hinge bracket and plastic guide, then screw in the lower hinge pin with the washer
between the door and bracket.
Note:- With care and assistance, the above procedure can be carried out with the cabinet in
the upright position once the unit has been secured to the wall.