User’s manual
14
EN
when pulling it through.
6. Carefully route the sensor and camera’s cables through the hole.
7. Connect the red cable (2) protected with a fuse to power (+12 V) eg. reverse
light, and black wire (3) to GND. Make a permanent connection using a crimp
connector or by soldering etc.
8. Connect buzzer (4).
9. Connect the camera’s cable to the rearview mirror (6) with AV cable (5).
10.
Adjust the lens and keep the lens parallel with the ground.
11. Turn on the vehicle's engine and switch on reverse gear. If the device has been
connected properly, the parking sensor will issue a short sound signal.
Before turning on
Execute all connections before connecting the device to power supply:
1.
Power off the car engine.
2. Insert memory card into appropriate slot.
Please note: the device supports memory card capacity of 512 MB - 32 GB, class 6
and higher.
3. Fasten the device instead of the original rear view mirror of car. Use the included
rubber bands to install the device on the car rearview mirror.
4. Connect the mirror to power supply: connect the car charger into cigarette lighter
socket and connect to mini USB port on the device.
Note: it is suggested to route car charger cable along the edge of the windscreen.
5. Start the engine to check if the DVR has been installed correctly.
iMPORtaNt
: if the sensor have been connected properly, the buzzer will issue a
short sound signal, which means proper operation.
