GB - 2
940-16 MLS-G (Rev02-120906)
ProgrAMMing Phc-softWAre
Attention!
Before the system can be programmed, Version 3.0 or later of the
PHC system software must first be installed! This can be downloa
-
ded from the internet at www.peha.de.
Phc-functions
The gateway’s PHC functions for the PHC and MLS systems must be pro
-
grammed in the PHC software V3.0 (see PHC manual).
The following func-
tions are available:
Phc input functions
Movement detected
Actor has been switched ON
Actor has been switched OFF
Zone(s) has/have been partitioned
Zone(s) has/have been rejoined
Scene 1 has been recalled (in one or multiple zones)
Scene 2 has been recalled
Scene 3 has been recalled
Scene 4 has been recalled
Scene 5 has been recalled
Scene 6 has been recalled
Movement in a vacant area/zone detected
Phc output functions
Intelligent ON (movement simulation)
Switch ON
Switch OFF
Partition
Rejoin
Quick Fade To Level & Time Out
Quick Fade To Level & Refresh Timer
Recall scene 1
Recall scene 2
Recall scene 3
Recall scene 4
Recall scene 5
Recall scene 6
Set scene 1
Set scene 2
Set scene 3
Set scene 4
Set scene 5
Set scene 6
Switch ON with timer
Switch ON with timing delay
Switch OFF with timing delay
Dim up with timing parameter
Dim down with timing parameter
Stop dimming
troubLeshooting & reMedies
neW systeM or existing systeM
• status Led = flashing red:
Check module address (DIP switch)
• Check PHC programming and transfer again
(see PHC manual).
contAct
Telephone: .............
+49 (0)2351 185-0
Fax: .......................
+49 (0)2351 27666
PHC-Support:..........
+49 (0)2353 9118 333
Internet: ................www.peha.de
E-mail: [email protected]
generAL inforMAtions
disPosAL of the device
Do not dispose of old devices in the household waste! The device must be
disposed of in compliance with the laws and standards of the country in
which it is operated!
The device contains electrical components that must be disposed of as
electronics waste. The enclosure is made from recyclable plastic.
WArrAnty conditions
These operating instructions are an integral part of both the device and
our terms of warranty. They must be handed over to the user. The tech-
nical design of the appliance is subject to change without prior notifica
-
tion.
PehA
products are manufactured and quality-checked with the latest
technology according to applicable national and international regulations.
Nevertheless, if a product should exhibit a defect, PehA
warrants to make
remedy as follows (regardless of any claims against the dealer to which
the end-user may be entitled as a result of the sales transaction):
In the event of a justified and properly-established claim, PehA
shall ex-
ercise its prerogative to either repair or replace the defective device. Fur-
ther claims or liability for consequential damage are explicitly excluded.
A justifiable deficiency is one in which the device exhibits a structural,
manufacturing, or material defect that makes it unusable or substantially
impairs its utility at the time it is turned over to the end-user. The warranty
does not apply to natural wear, unintended usage, incorrect connection,
device tampering or the effects of external influences. The warranty period
is for 24 months from the date of purchase by the end-user from a dealer
and ends not later than 36 months after the device’s date of manufacture.
German law shall be applicable for the settlement of warranty claims.
PEHA Elektro GmbH & Co. KG
Postfach 1727 • D-58467 Lüdenscheid • Internet: www.peha.de
