Page 5
USE AND MAINTENANCE MANUAL
Rev. 02-18
PLUS
100
AB
IMPORTANT INFORMATION FOR THE INSTALLER
1.
Install the device in places where the protection rating is observed and try not to
damage the box when drilling holes for wire/pipe seats.
2.
Do not use multi-polar cables in which there are wires connected to inductive/power
loads or signalling wires (e.g. probes/sensors and digital inputs).
3.
Do not fit power supply wiring and signal wiring (probes/sensors and digital inputs) in
the same raceways or ducts.
4.
Minimise the length of connector wires so that wiring does not twist into a spiral shape
as this could have negative effects on the electronics.
5.
Fit a general protection fuse upstream from the electronic controller.
6.
All wiring must be of a cross-section suitable for relevant power levels.
7.
When it is necessary to make a probe/sensor extension, the wires must be of the
correct cross-section, which in any case must be at least 1mm
2
.
STANDARD ASSEMBLY AND USE KIT
The
PLUS100 AB
system is supplied with the following assembly and utilisation items:
n°1 console fixing bracket;
n°2 temperature sensors (piercing temperature probe not included);
n°1
user’s manual;
CHAPTER 2: INSTALLATION
CHAP. 2 - Installation
2.1
2.2
