Pegasus FS700 Series, Инструкция по эксплуатации

Страница: 8 / 36

W
W
ARNING
ARNING
Cables
1.When connecting the cables between the machine and the motor,
be sure to turn off the power and connect each cable connectors
securely.
2.Do not strain the cables in use.
3. Do not bend the cables excessively.
4.When connecting the cables that are close to the moving parts,
such as pulley or V belt, keep a distance of 25mm at least
between them.
5.Protect each cable using a cover or adjusting its position if
necessary.
6. Never use staples to fasten the cables.
Otherwise it causes a short circuit and/or a fire.
CA
CA
UTION
UTION
Motor
1.Install the machine motor correctly by referring to the instruction
manual supplied by the manufacturer.
2.Select the machine motor equipped with the pulley cover so that
any part of your body etc. is not caught in the belt.
CA
CA
UTION
UTION
Ground
1.Connect each of the ground wires in the sewing machine system
to the ground terminal. Do not connect to another devices'.
2. Connect the ground wires securely to the indicated ground
points on the machine head.
W
W
ARNING
ARNING
④
Handling machine oil
1. Before running the machine, check to see if the oil reservoir is
filled with oil. Use Pegasus recommended oil (P-68 made by
Yanase). (ISO Viscosity Grade 68)
2.If machine oil gets in your eyes, it may cause eye irritation.To
prevent the machine oil from getting in your eyes, wear a pair of
protective glasses.
※
Should machine oil gets in your eyes, wash them with fresh water
for 15 minutes and then go to see a doctor.
Be sure to study very carefully
for
for
safety.
safety.
5
W
W
ARNING
ARNING
② Transportation
1.The machine should be carried by at least more than two people
when it is mounted on the table and/or a hand truck.
Be sure to use a hand truck for other transportation.
2. To move the machine head
Hold the underside of the oil
reservoir with your left hand
(Be careful not to pin your
left hand under the machine
head when putting it down).
Hook and hold the left side
of the arm with your right
hand. To prevent accidents,
wipe oil off the surface of the
machine head and your hands.
3.Care should be taken to avoid excessive shock and shake when
the machine is mounted on the table and/or transferred using a
hand truck. Otherwise the machine may fall down.
4.Wipe off the oil from the machine before packaging it again for
secondary transport. Otherwise the machine may easily slip out
of your hands or the bottom of the box may come off while in
transit.
CA
CA
UTION
UTION
③ Installation, preparation
Machine table
1.Use the machine table (table board, metal legs) that completely
carries the machine and is fully resistant to warping while the
machine is running.
2.Arrange the working environment for easy operation by
considering where to place the machine and the brightness
around the working area. If the illumination is insufficient, control
or change lighting as required.
3.Attach a non-slip pad to the treadle (foot switch).
Otherwise the operator may slip off the treadle while running the
machine, causing trouble.
4.Adjust the height of the table according to a working posture of
the operator.
From the library of: Superior Sewing Machine & Supply LLC