Peg-Perego Carrello easy drive, Инструкция по эксплуатации

Страница: 10 / 40

- 10 -
EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
IMPORTANT: read these instructions carefully and
keep them for future use. The child’s safety could be
at risk if these instructions are not followed.
_ This product was designed for the transport of 1 child
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ The Easy Drive chassis is designed for use with Peg-
Perego Ganciomatic products: the Easy Drive chassis
+ Primo Viaggio car seat (0+ group) is approved for
children from birth up to 13 kg of weight. The Easy
Drive c “Navetta” bassinet unit is approved for
children from birth up to 9 kg of weight.
_ This product was designed for use in combination
with the following Peg Perego Ganciomatic products:
the “Primo Viaggio Tri-Fix” car seat (Group 0+),
Navetta XL (gruppo 0), seggiolino Switch.
_ WARNING Check that the pram body or seat unit or
car seat attachment devices are correctly engaged
before use; check that the Peg Perego Ganciomatic
products are correctly fixed to the item.
_ The assembly and preparation of the product must be
carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING Always use the restraint system; Always
use the five point harness; always use the harness
crotch strap in combination with the waist strap.
_
WARNING
Never leave your child unattended.
_ Always apply the brake when stationary.
_ WARNING Ensure that all the locking devices are
engaged before use.
_
WARNING
To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_ WARNING Do not let your child play with this
product.
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer’s instructions as regards the maximum
loads transportable.
_ The front bar is not designed to support the child’s
weight. It is not designed to keep the child in the seat
and does not substitute for the waist belt.
_ Do not load the baskets over 5 kg. Do not put weight
in the cup holder in excess of those indicated on the
cup holders themselves and never hot drinks. Do not
put loads of more than 0.2 kg in the hood pockets (if
present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ The use of accessories not approved by the
manufacturer could be dangerous.
_ Do not use the rain canopy (if present) indoors and
regularly check to ensure the child is not too warm;
do not park the stroller close to heat sources and keep
well away from lighted cigarettes. Ensure the rain
canopy is not interfering with any moving parts of the
carriage or stroller; always remove the rain canopy
before folding your carriage or stroller.
_ Do not use the release levers to move or lift the
stroller when the child is in it.
_ WARNING This product is not suitable for jogging or
skating.
_ Apply the brake when loading or unloading children.
COMPONENTS OF THE ITEM
Check the contents of the packaging. For any
complaints, please contact the Customer Service
Department.
_ Carrello Easy Drive: A basket; 2 swiveling or locking
front wheels; 2 rear wheels with a central brake bar;
and a drink holder.
INSTRUCTIONS
1 OPENING: Raise the levers on the handlebar together
(fig_a) and pull upwards until the chassis is completely
open (fig_b). Check that the chassis is correctly
opened: the side tubes must be locked together
(fig_c). Lastly, slide the two elements along the handle
as shown in the figure (fig_d).
2 Attach the rear wheels to the chassis (fig_a) and
secure them with the screws and nuts. Put the screw
on the outside (on the wheel side) and the nut inside,
then tighten the screw (fig_b).
Attach the central part of the brake bar to the chassis
(fig_c) and check that it has clipped into place
properly (fig_d).
3 FITTING THE BASKET: Slip the loops onto the hooks at
the front (fig_a) and the rear (fig_b).
4 FITTING THE CUP HOLDER: insert the cup holder on the
corresponding peg and press down until it clicks into
place (fig_a). The cup holder can be attached to either
side of the chassis.
5 ADJUSTABLE HANDLEBAR: Carrello Easy Drive: To
adjust the height of the handlebar, press both of the
side buttons at the same time (fig_a) and lock it in the
desired position (fig_b).
6 FIXED OR SWIVELLING FRONT WHEELS: Lift the levers
to prevent the wheels from swiveling (fig_a) and lower
them to allow the wheels to swivel (fig_b). On uneven
surfaces, the wheels should be set to their fixed
position.
7 BRAKES: Press a brake lever to immobilize the chassis
(fig_a) and lift the lever to release it (fig_b).
8 MOUNTING THE SEAT TO THE CHASSIS: the reversible
seat can be attached to the chassis either facing
the person pushing the stroller (fig_a), or facing
forwards (fig_b), place the seat on the chassis so
that it is aligned with the relative symbols and press
downwards with both hands until you hear two clicks
confirming that it has locked into position. Ensure
the seat is correctly secured by attempting to pull it
upwards by gripping the front bar.
9 REAR LEDGE: the rear ledge makes it easier to negotiate
kerbs or level differences with the stroller (fig_a).
10 FOLDING UP: The stroller can be folded up without the
seat, with the seat facing the person pushing (recline
the backrest before folding it) or with the seat facing
forward (raise the backrest before folding it and recline
it once it is folded).
To fold up the stroller, slide the two elements along
the handlebar as shown in the figure (fig_a), set the
front wheels to fixed mode and fold up the hood if it is
on.
Raise the two levers on the handlebar one at a
time until they click (fig_b) and push down on the
handlebar (fig_c) to unclip the side tubes at the front
(fig_d);
11 Pull up the central handle (fig_e). Check the correct
closure of the chassis from the safety hook (fig_f). With
the seat facing the person pushing, the folded chassis
can be made even more compact by lowering the
handlebar (fig_g). The stroller is freestanding when
folded up.
12 TRANSPORT: the stroller can be carried by the central
handle, keeping the front wheels fixed (fig_a) or by the