Peg-Perego carrello book, Инструкция по эксплуатации

Страница: 47 / 80

- 11 -
EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
IMPORTANT: read these instructions carefully
and keep them for future use. The child’s safety
could be at risk if these instructions are not
followed.
_ This product was designed for the transport of 1 child
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ This vehicle is designed for children from birth to a
weight of 15 kg.
_ This product was designed for use in combination
with the following Peg Perego Ganciomatic products:
Carrello Book, Carrello Easy Drive, Carrello Compact,
Carrello Four.
_
WARNING
Check that the pram body or seat unit or
car seat attachment devices are correctly engaged
before use; check that the Peg Perego Ganciomatic
products are correctly fixed to the item.
_ The assembly and preparation of the product must be
carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_
WARNING
Always use the restraint system; Always
use the five point harness; always use the harness
crotch strap in combination with the waist strap.
_
WARNING
Never leave your child unattended.
_ Always apply the brake when stationary.
_
WARNING
Ensure that all the locking devices are
engaged before use.
_
WARNING
To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_
WARNING
Do not let your child play with this
product.
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer’s instructions as regards the maximum
loads transportable.
_ The front bar is not designed to support the child’s
weight. It is not designed to keep the child in the seat
and does not substitute for the waist belt.
_ Do not load the baskets over 5 kg. Do not put weight
in the cup holder in excess of those indicated on the
cup holders themselves and never hot drinks. Do not
put loads of more than 0.2 kg in the hood pockets (if
present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ The use of accessories not approved by the
manufacturer could be dangerous.
_ Do not use the rain canopy (if present) indoors and
regularly check to ensure the child is not too warm;
do not park the stroller close to heat sources and keep
well away from lighted cigarettes. Ensure the rain
canopy is not interfering with any moving parts of the
carriage or stroller; always remove the rain canopy
before folding your carriage or stroller.
_ Do not use the release levers to move or lift the
stroller when the child is in it.
_
WARNING
This product is not suitable for jogging or
skating.
_ Apply the brake when loading or unloading children.
PRODUCT CHARACTERISTICS
_ The item is numbered progressively.
_ The Seggiolino Switch is a reversible seat: it can turn
to face mum or to face outwards.
PRODUCT COMPONENTS
Check all packaging contents and contact the
Customer Help Service if you have a complaint.
_ Full Seggiolino Switch: hood, cover, rain canopy.
_ Casual Seggiolino Switch: hood, rain canopy.
INSTRUCTIONS
1 FRONT BAR: Before attaching the front bar, press the
buttons on the sides of the armrests and remove
the caps (fig_a). To attach the front bar, guide the
connections into the armrests and push towards the
seat until they click into place (fig_b). To remove the
front bar, press the two buttons and pull it out (fig_c).
To make it easier for the child to get in and out, it is
possible to open the front bar on one side only. If you
wish to use the stroller without the front bar, put the
caps back in the armrests.
2 BACKREST: to recline the backrest lift the lever (fig_a)
and choose one of the 4 positions (fig_b).
3 FOOTREST: to lower the footrest push the two levers
downwards and then push the footrest downwards
(fig_a); to raise the footrest lift it upwards (fig_b).
4 FIVE POINT SAFETY HARNESS: To fasten it, push the
two waist strap buckles (with the shoulder straps
attached – arrow_a) into the leg divider until they click
into place (arrow_b). To unfasten it, press the round
button in the centre of the buckle (arrow_c) and pull
the waist straps out (arrow_d).
5 To tighten the waist strap, pull on both sides in the
direction of the arrow (arrow_a). To loosen it, move it
in the opposite direction.
6 To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow_a) until
the buckles are released and insert them in the
backrest loops (arrow_b). Remove the shoulder straps
from the sack (arrow_c) and insert them in the most
appropriate loop (arrow_d), then re-attach the two
buckles on the rear of the backrest (arrow_e) The
buckles are securely attached when a click is heard
(fig_f).
7 HOOD: to attach the hood insert the connections
into the sides of the seat (fig_a) and then fasten the
buttons on the rear of the backrest (fig_b). To remove
the hood: disengage the connections and unbutton
from the backrest. To raise the hood: pull it towards
you; to close the hood: push it back. To convert the
hood into a sun canopy, open the double zipper (fig_c)
and unfasten the buttons on the rear of the backrest.
The child’s favorite toy can be hung from the loop on
the hood (fig_d).
8 COVER: put on the cover, and fasten it underneath
(fig_a) and on the sides of the footboard. For the
baby carriage version, move the footboard up and
place the cover over the front bar (fig_b), fastening
it to the buttons of the hood (fig_c). For the stroller
version, move the footboard down, insert the cover
underneath the front bar (fig_d) and fix it in place.
9 LIGHT COVER: can be attached onto the Navetta XL
and the Seggiolino Switch. For instructions on how to
attach it to the Navetta XL, consult the user manual.
To attach it to the Seggiolino Switch, unfasten the Velcro
inside the cover (fig_a), put the cover on the seat and
fasten it with the Velcro on the footboard of the seat
(fig_b).
Turn up the tab of the cover onto the front bar (fig_c) and
fasten it on the sides with the Velcro (fig_d).
10 ATTACHING THE SEAT ONTO THE CHASSIS: the