2 of 27
ISSUED: 05-17-07 SHEET #: 202-9208-3 5-7-08
Visit the Peerless Web Site at www.peerlessmounts.com
For customer care call 1-800-865-2112 or 708-865-8870.
Note:
Read entire instruction sheet before you start installation and assembly.
Tools Needed for Assembly
•
stud finder ("edge to edge" stud finder is recommended)
•
phillips screwdriver
•
drill
•
1/4" bit for concrete and cinder block wall
•
1/2" bit for metal stud wall
•
5/32" bit for metal or wood stud wall
•
level
Table of Contents
Parts List .............................................................................................................................................................................. 3
Installation to Double Wood Stud Wall .................................................................................................................................. 4
Installation to Triple Wood Stud Wall .................................................................................................................................... 5
Installation to Solid Concrete or Cinder Block ....................................................................................................................... 6
Installing Vertical Brackets ................................................................................................................................................... 7
Installing Flat Panel Screen to Wall Plate ............................................................................................................................. 9
For customer care call (800) 865-2112 or (708) 865-8870.
Accessories
•
4 piece Metal Stud Fastener Kit (ACC 415) (Metal Stud
not evaluated by UL)
•
2 piece Metal Stud Fastener Kit (ACC 215) (Metal Stud
not evaluated by UL)
• Do not begin to install your Peerless product until you have read and understood the instructions and warnings
contained in this Installation Sheet. If you have any questions regarding any of the instructions or warnings, please
call Peerless customer care at 1-800-865-2112.
• This product should only be installed by someone of good mechanical aptitude, has experience with basic building
construction, and fully understands these instructions.
• Make sure that the supporting surface will safely support the combined load of the equipment and all attached hard-
ware and components.
• Never exceed the Maximum UL Load Capacity. See page one.
• If mounting to wood wall studs, make sure that mounting screws are anchored into the center of the studs. Use of an
"edge to edge" stud finder is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
• Tighten screws firmly, but do not overtighten. Overtightening can damage the items, greatly reducing their holding
power.
• This product is intended for indoor use only. Use of this product outdoors could lead to product failure and personal injury.
• This product was designed and intended to be mounted to the following supporting surfaces checked below with the
hardware included in this product as specified in the installation sheet. To mount this product to an alternative support-
ing surface, contact Peerless customer care at 1 800 865-2112.
• This product was designed to be installed on the following wall construction only;
WALL CONSTRUCTION
ADDITIONAL HARDWARE REQUIRED
x
Wood Stud
None
x
Wood Beam
None
x
Solid Concrete
None
x
Cinder Block
None
Metal Stud
Do not attach except with Peerless accessory kit for metal studs;
Contact Customer Service for Peerless accessory kit for metal studs.
Brick
Contact Customer Service
Other or unsure?
Contact Customer Service
WARNING
