9 of 27
ISSUED: 01-11-08 SHEET #: 202-9271-2 02-22-08
Visit Peerless website at www.peerlessmounts.com
For customer care call 1-800-729-0307 or 708-865-8870
• Always use an assistant or mechanical lifting equipment
to safely lift and position the flat panel screen.
• Do not tighten screws with excessive force. Overtightening
can cause damage to mount.
Tighten screws to 40 in. • lb
(4.5 N.M.) maximum torque.
• Be careful not to pinch fingers when pushing screen from
the bottom.
For preset tilt angles use Increlok™ and for custom tilt
angle use ratchet handle.
INCRELOK™:
The screen can be locked into a
pre-set tilt position of -5°, 0°, 5°, 10° or 15°. Use
locator hole to find tilt position hole and tilt screen to
align holes. Tighten IncreLok™ tilt locking screws on
both tilt brackets to lock tilt as shown in detail 2.
Ratchet Handle:
Loosen ratchet handle (refer to step
3 for tension adjustment of handle). Push or pull from
top or bottom of screen to adjust tilt as shown in figure
4.1. The tilt can be adjusted to a maximum of 15°
forward or 5° backward.
Tension Adjustment of Ratchet Handle:
Adjust
tension in tilt brackets (
BB & CC
) by rotating ratchet
handle.
NOTE:
If obstruction prevents ratchet handle
from rotating, pull handle out while turning will allow
handle to reposition without tightening. Release and
turn handle to tighten or loosen.
Mounting Screen:
Ratchet handle
must
be in the up or
down position or interference will occur while hooking tilt
brackets to wall plate (
AA
). Slowly hook tilt brackets
(
BB & CC
) onto wall plate (
AA
) and swing screen down
as shown in fig. 3.1. Tilt bracket hooks must fully
engage wall plate as shown in detail 1. Using phillips
screw driver or security allen wrench (
FF
), turn safety/
security screws on tilt brackets (
BB & CC
) clockwise till
screw tip securely contacts wall plate as shown in
cross section.
Screen Adjustment:
Screen can be adjusted
horizontally by loosening safety/security screws on tilt
brackets (
BB & CC
) three full turns. Adjust screen as
shown in figure 3.2. Tighten safety/security screws on
tilt brackets till screw tip securely contacts wall plate
as shown in cross section.
Removing Screen:
To remove screen from mount,
loosen safety screws, swing screen away from mount,
and lift screen off of mount.
© 2007, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Mounting and Removing Flat Panel Screen
DETAIL 2
fig 4.1
IncreLok™
TILT LOCKING
SCREW
LOCATOR
HOLE
RATCHET
HANDLE
TILT
POSITION
HOLES
fig 3.2
3
Adjusting the Tilt Angle of the Flat
Panel Screen
4
WARNING
SAFETY/
SECURITY
SCREW
CROSS SECTION
DETAIL 1
AA
BB
&
CC
BB
&
CC
AA
fig 3.1
RATCHET
HANDLE
