8 of 42
ISSUED: 09-10-09 SHEET #: 202-9367-7 04-05-11
For Flat Back Displays
For Bump-Out or Recessed Back Displays
Begin with the shortest length screw, hand thread through washer, tilt bracket and spacer, if required, into display
as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a longer length
screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
NOTE:
Spacers may not be used depending on the type of display.
NOTE:
If display manufacturer's requirements state that more than 0.68" of ventilation is required, spacers may be
used to add an additional 0.5" (spacer
P
) or 0.75" (spacer
Q
) of space between the wall and the display as shown
below.
Begin with the shortest length screw, hand thread through washer, tilt bracket and spacer as required into display
as shown below. If screw cannot make three full turns into the display and fi t snug into place, select a longer length
screw from the baffl ed fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.
If you have any questions, please call Peerless customer care at
1-800-865-2112
If you have any questions, please call Peerless customer care at
1-800-865-2112
Display
Display
SPACER
WASHER
WASHER
SCREW
SCREW
TILT BRACKET (
B
)
TILT BRACKET (
B
)
TILT BRACKET (
B
)
Display
SPACER
WASHER
SCREW
2-1
2-2
