Pg. 4
Pg. 5
5. Insert the handlebar stem into the header tube on the bicycle. You adjust
the height of the handlebars stem up or down to your comfort level. Do not
set handlebars stem higher than the maximum height indicator located on the
stem. Place thumb on black locking mechanism on top of stem, push down
and lift lever up exposing adjustment screws.
Assembly Instructions
Your bike has been pre-assembled and requires only a few simple steps to
get it ready for you to ride:
1. Remove the bicycle from carton after cutting the nylon bands and put the
kickstand down.
2. Remove all of the protective wrap covering the bicycle. When removing
the protective wrap on handlebars, be careful to NOT engage the front brake
lever (Left Lever) with the front wheel still unattached.
3. Please locate and put aside the box which includes the pedals, battery
charger and tool kit.
4. Install the front wheel by aligning the brake and fork, and tightening the
axle nuts with the 15mm wrench provided with your kit. Make sure that the
hooked washers are on the outside of the fork, and are properly secured.
If the disc brake is rubbing after installation, refer to Customer Help on our
website at www.pedegoelectricbikes.com/faqs/customerhelp/
For City Commuter
