Pedego conveyor, Инструкция по сборке и руководство пользователя

Страница: 44 / 56

44
TROUBLESHOOTING
Error codes continued
Error
Code
Description Solution Approach
42 Fault in motor rotation. Switch off the system completely
and then back on using the Control
Panel button T4. If the problem
persists, contact your e-bike dealer.
43 Short circuit in motor.
44 Overheating of motor. Reduce the load on the motor by
pedaling less or by reducing the
assist level.
45 The software has corrected an
error in motor rotation. Switch off the system completely
and then back on using the Control
Panel button T4. If the problem
persists, contact your e-bike dealer.
46 No motor movements
recognized.
60 Interruption to data exchange
on the CAN-BUS. Check the cables and plug
connections of all components of
the e-bike system.
70 Force applied to pedal not in
valid range.
Switch off the system completely
and then back on using the Control
Panel button T4. If the problem
persists, contact your e-bike dealer.
71 Turning of pedals not detected.
72 Force applied to pedal not
detected.
73 The connection to the pedal
force sensor has been
interrupted.
74 Errors were found in the data
80 Incorrect motor parameter.
81 Speed signal not recognized. Ensure the magnet is correctly
positioned relative to the speed
sensor.
82 The program was manipulated. Switch off the system completely
and then back on using the Control
Panel button T4. If the problem
persists, contact your e-bike dealer
83 Error in program sequence.
84 Incorrect motor parameter.
Troubleshooting