Peco Pro 12 DFS 49621204, Руководство оператора

Страница: 11 / 34

11
NOTE: The PTO Handle can be adjusted after achieving proper belt adjustment. To adjust the handle, remove (3)
1/4”-20 x 3/4” HHCS (Item#3) and (3) 1/4”-20 Ny-Flange Lock Nuts (Item#4), rotate handle until positioned in the
desired location (while aligning holes) and replace the hardware. The bolts should be kept approximately 120
degrees apart to ensure proper fastening.
PTO Assembly & Handle Assembly Installation
To mount the PTO Assembly, insert the Pivot Rod on the PTO Assembly P#(A1623) into the mounting slots located
on the Left & Right PTO Mount Plates (Figure A). Tilt the PTO Assembly upward and insert the PTO Mount Pin
P#(B0274) through the hole in the top of the Right PTO Mount Plate Assembly. Secure the PTO Mount Pin using (1)
1/8” Hair Pin Clip P#(K0086) as shown below.
Note: Remove the gearbox pulley guard in preparation for the belt installation. Refer to Figure A.
To install the PTO Handle (Item#1), attach the PTO Handle to the PTO Assembly using (3) 1/4”-20 x 3/4” HHCS
(Item#3) and (3) 1/4”-20 Ny-Flange Lock Nuts (Item#4). Attach the Handle Grip (Item#2) to the PTO Handle. Refer to
Figure B
1
2
3
4
4
3
3
4
Remove Gear
Box Pulley Guard
Pivot Rod
PTO Mount Pin P#(B0274)
and Hair Pin Clip P#(K0086)
Figure A
Figure B
Item # Part # Desc. Qty.
1 A0626 PTO ENGAGE. HANDLE ASSY. 1
2 J0522 HANDLE GRIP, ROUND BLACK .800 ID 1
3 K1222 1/4"-20 X 3/4" HHCS 3
4 K2014 1/4"-20 Ny-Flange Lock Nut 3
A1142