Peco 50721201, Руководство оператора

Страница: 5 / 22

5
1-1 Introduction
We are pleased to have you as a PECO customer. Your
collection system has been designed to give you a low
maintenance, simple, and effective way to collect the
grass clippings from your mower. This manual is
provided to give you the necessary instructions to
properly mount and operate the collection system on
your mower. Please read this manual thoroughly.
Understand what each control is for and how to use it.
Observe all safety decal precautions on the machine and
noted throughout the manual.
NOTE : all references made to right, left, front, rear, top
or bottom are as viewed from the normal operator’s
position on the mower.
1-2 Description
The collection system is designed for turf maintenance
where there is a need to collect the grass clippings as
the mower cuts the turf. It is also good for picking up
leaves and twigs in pre-season and post-season clean-
up.
The blower, mounted on the right side of the unit, uses a
belt and gearbox system from the engine PTO shaft.
Drive train protection comes through belt slippage. The
blower draws grass clippings from the discharge area of
the cutter deck up to the aluminum container mounted
over the rear portion of the mower frame. The operator
can engage the blower with a push of the over-center
linkage on the right side of the unit. Once the container is
full of clippings, the operator can easily push and raise
the lift handle, releasing the container’s rear door and the
container will pivot towards the ground.
Section II
INSTALLATION FOR USE
2-1 Preparation Of Mower
Carefully dismantle wooden shipping crate from around
the components. Cut retaining straps and separate the
parts. The collection system will have various parts
located inside. Remove and sort all parts for easy
identification.
NOTE: before each step of assembly it will help to study
the exploded drawings on pages 10 -14.
From the underside of the engine remove the bolt and
bushing from the electric clutch assembly. Replace these
parts with the engine pulley assembly P#(A0198), 7/16”
lock washer P#(K0053), and 7/16”-20 x 4” HHCS
P#(K0359).
SECTION I
INTRODUCTION AND DESCRIPTION
The added pulley will power the collection system. Note
that the center of the hub that is extended should be
upward toward the engine (Figure 2-1a). Torque the bolt
to 55 ft./lbs.
NOTE: Before installing the PTO mount plate assembly
and exhaust deflector, the rear chassis of the mower
must be removed for clearance. After installation, re-
attach the rear chassis to the mower.
To remove the rear chassis of the Warrior series mower,
remove (2) 3/8”-16 x 1” existing nuts and bolts per side
(see Figure 2-1b) and (2) 3/8”-16 x 1” existing bolts from
frame (see Figure 2-1c).
Figure 2-1b.
Figure 2-1a.
Electric Clutch
Engine Pulley Assy.
Remove (2) Existing
3/8”-16 x 1” HHCS And
(2) Existing 3/8”-16
Flange Nuts Per Side