Upper Frame
Assembly
Outer Engine
Mount Tube
Assembly
Figure 2-11a
Figure 2-11b
2-11 Upper Frame Assembly Installation
NOTE
:
During this step, it is suggested that two people
install the upper frame to the lower mount tube.
Using (2) people to lift the upper frame P#(A0585), lift
the upper frame above the lower mount assembly
P#(A1720) making sure the frame is pointing away from
the mower (Figure 2-11a). Slide the upper frame tube
into the lower mount assembly and align holes. Secure
with (1) clevis pin P#(K0133) and (1) hair pin clip
P#(K0088). Refer to Figure 2-11b
11
2-12 Top Assembly To Upper Frame
Assembly Installation
Align the pivot brackets of the top assembly P#(A0551)
to the pivot point on either side of the upper frame
assembly. Place (1) fender washer P#(K0041) between
each pivot point per side and fasten each side by using
(1) P#(K1153) 5/16”-18 x 3/4” HHCS and (1) P#(K1180)
5/16”-18 nyloc nut. When fastening leave nut slightly
loose so that the top can pivot freely. Refer to Figure 2-
12a.
Clevis Pin
Hair Pin Clip
Figure 2-12a
5/16”-18
Nyloc Nut
Fender
Washer
5-16”-18 x 3/4”
HHCS
Top Assembly
Goes Here
