12
Back Panel
POWER AMP 2 SPEAKER OUTPUTS (MAIN MIX or MONITOR MIX)
Dual two-conductor ¼” – Speakon combination jacks that can be connected to your speakers. Each amplifier has a minimum load imped-
ance of 4 ohms. This means you can connect either one 4-ohm, one 8-ohm or two 8-ohm speakers to each amplifier. Do not operate below
rated minimum impedance. For maximum power transfer and to prevent damage to your amplifier, be sure to use speaker cables and not
instrument cables to connect to the speakers. We recommend the use of 18-guage or larger speaker wire. The signal going to Power Amp 2 is
determined by the position of the Power Amp 2 Assign switch (20). In the “MAIN” position, the main mix is fed to power amp 1 and power
amp 2. In the “MON” position, the main mix is fed to power amp 1 and the monitor mix is fed to power amp 2.
Footswitch (TRS) Effects Defeat/Mic Mute (Global)
This 1/4" (TRS) jack accepts a momentary 1/4" TRS dual button footswitch (Peavey part # 03014070) designed to defeat the effects (tip to
sleeve) and activate the MIC MUTE switch (39, ring to sleeve). The status of either function will be displayed by the lighting of the switch on
the front panel. If the effects are muted, either by the footswitch or the front panel switch (33), the EFX MUTE switch will glow red. If the
Mics are muted, either by the footswitch or the front panel switch (39), the MIC MUTE switch will glow red.
A single button footswitch (Peavey part # 03050680) can be used, but it will only work on the "Effects Defeat". In this case, the "Mic Mute"
status can only be toggled by the front panel switch (39).
52
53
