Peavey IRM 8150, Руководство пользователя

Страница: 6 / 16

6
LINE INPUT JACK (18)
For use with line level signal or compatible high Z microphones equipped with a 1/4" phone plug.
NOTE:
These input jacks (17 & 18) are typical of each channel. It is possible to use both the mic and line inputs
on a single channel simultaneously. It is, however, unlikely that the gain matching of the mic and line will allow
this hookup to be useful. This practice is not recommended.
PHANTOM POWER ON/OFF (19)
This switch selects phantom power "ON" or "OFF" for all channels. Phantom power is on when the switch is in
the in position and off when the switch is in the out position. This switch should be activated for use with con-
denser-type microphones. Phantom voltage is +48 V DC on pins 2 and 3 referenced to pin 1.
MAIN OUTPUT (20)
This 1/4" jack provides a signal from the main system mix before the graphic equalizer. Used primarily to feed
an auxiliary amplifier/speaker system. (See wiring diagram).
MONITOR OUTPUT (21)
This 1/4" jack provides a signal from the MONITOR mix for an external monitor amplifier/speaker system. The
level is determined by the channel monitor and master monitor controls.
AUX OUTPUT (22)
This 1/4" jack provides a signal from the AUX mix for external effects or signal-processing equipment. This
output can also be used for other purposes if external effects are not required. These include building a separate
mix for recording or broadcasting.
GRAPHIC INPUT (23)
This 1/4" jack provides an input to the internal graphic equalizer/power amp. This is a switching jack: a signal
inserted here interrupts the normal signal path from the main bus into the equalizer.
OPERATION NOTE:
This jack permits the equalizer to be switched away from its normal input and accept an
external signal to be equalized, such as the monitor output.
GRAPHIC OUT (24)
This 1/4" jack provides access to the output of the internal graphic equalizer. A plug inserted into this jack does
not switch the EQ output away from the input to the power amplifier.
AUXILIARY INPUT (25)
This 1/4" jack provides access to an input to the main mixing bus for patching in returns from external effects
devices, extra mixing channels, etc. Using this jack defeats both tape in jacks.
POWER AMP INPUT (26)
This 1/4" jack provides access to connect external line-level signals to the power amplifier.
OPERATION NOTE:
This jack permits the internal power amplifier to be switched away from its normal input
and to accept external line-level signals.
AC POWER AND POWER AMPLIFIER OUTPUT SECTION:
FUSE (27)
The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED WITH
THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PRE-