Use of the DM™115 with a Speaker Stand
The DM™115 has a stand mount cup molded-in so that the system can be stand mounted on a standard 1 3/8”
(36mm) diameter stand pole.
When using stands or poles, be sure to follow these precautions:
A.
Check the stand or pole specs to make sure that it can support the weight of the DM™115 (42 lbs./19.1
kg), and observe all safety precautions stated by the stand manufacturer, including the maximum height
the stand is rated for.
B.
Always place the stand on a flat, level and stable surface, and be sure to fully extend the stand legs as per
the stand manufacturer’s instructions.
C.
Try to make sure that the stand legs are oriented for the least danger of tripping to those in the vicinity of
the stand. Never block a doorway or hallway with the legs of a stand.
D.
Try to route cables so that people will not trip over them, or tip the speaker over. Use of duct tape, cable
channels or guards, or other appropriate tie-down/cover –up devices should be carefully considered and imple-
mented.
E.
When installing or de-installing the speaker on the stand, it is a good practice to have a helper if possible,
it can be hard to “thread the needle” and mate the stand cup to the stand pole while holding the DM™115 speaker
system at arm’s length. It is also helpful if someone holds the speaker stand and pole down while the DM™115 is
removed from the stand pole, this prevents the DM™115 from pulling the pole up with it.
F.
When using stands outdoors, never attach banners or flags to the stands or the DM™115 speaker system,
strong winds may cause the speaker to blow over. If there is a possibility of windy conditions, then it may be
prudent to consider weighting or locking down the stand legs to prevent the DM™115 speaker system from being
blown over.
Use of the DM™115 with a DM™115 Sub or DM™118 Sub
The DM™115 Sub or DM™118 Sub can be used with a DM™115 using the threaded 1 3/8” diameter pole supplied
with the Sub. All the precautions stated for use of the DM™115 with a speaker stand should be applied as appro-
priate to use of the DM™115 with a DM™115 Sub or DM™118 Sub. That would be primarily items B, D, E and F.
Connecting a Signal to the DM™115
There are a variety of ways to input a signal to the DM™115.
The input (5) provides either a balanced mic- or line-level input, allowing the use of a 1/4" TRS (ring-tip-sleeve)
type phone plug or a male XLR plug.
Do not connect cables to the jacks while the unit is ON and the Gain knob is turned up! While a standard
single-ended 1/4" phone plug-equipped cable will work well and the balanced input circuitry will provide some
interference rejection, a balanced cable using either the balanced TRS 1/4" phone plug or the XLR plug will pro-
vide superior interference rejection and performance.
Sometimes, with difficult interference problems, it will be helpful to lift the shield ground ( Pin #1 of an XLR) of
a balanced cable at the DM™115 end. Check any input changes carefully, always turning the Level control down
before plugging and unplugging cables, or lifting the ground.
Use of high quality, premium cables is recommended for the DM™115, as these usually have better shielding and
materials and will provide greater long-term reliability. The best option is a shielded balanced cable no longer
than necessary to reach the DM™115. It is usually a good idea to leave some slack at the input to the DM™115
and also to tape the cables down or run them under a cable guard to avoid anyone tripping over them or pulling
the DM™115 over when stand mounted..
Level Control Adjustment
The DM™115 is equipped with a Level control (6) on the input to facilitate use in many different applications.