UPPER REAR PANEL
INPUT (5)
The line-level input is of the medium impedance balanced type. The jack is a combo female XLR and 1/4" TRS
connector.
Sensitivity of this input is 0.39 volts for full output, when the MIC/LINE switch (7) is in the LINE position
GAIN (6)
Controls the gain or output level of the input signal. It is used to directly set the system output level for a given
input signal.
MIC/LINE switch (7)
Switches between LINE level gain (out position) and MIC level gain (in position). MIC position increases gain
20 dB to allow use of most dynamic microphones.
NOTE: Phantom power is not supplied on the INPUT (5) jacks
Gnd LIFT switch (8)
Allows the shield to be disconnected from the chassis ground to alleviate hum from ground loops
LED (9)
Illuminates green when the power switch is on and power is present
It turns Red when the power amp engages the DDT “Soft Limiting” circuitry.
THRU jack (10)
This jack is intended for the use of linking multiple DM™115’s in a line
or to provide a feed to a powered subwoofer, or other electronics that needs to receive a full range version of the
input signal.
LCD Display (11)
Provides a menu read-out manipulated and activated by the Push-To-Select button (12)
5
10
9
8
7
6
11
12
