Peavey DPE118P, Руководство по эксплуатации

Страница: 13 / 16

SPECIFICATIONS
F
requency Response, 1 meter on-axis, swept-sine in anechoic
environment (+/- 3 dB):
53 Hz – 162 Hz* *Crossover Control Full CW
Usable Low Frequency Limit, 1 meter on-axis, swept-sine in
anechoic
environment (-10 dB point): 43 Hz
Internal power amplifier into 4 ohm:
Peak Dynamic Power - 1200 watts
Continuous Power: 450 watts @ less than 1% distortion
Nominal sensitivity (1W @1M, swept
sine input in anechoic environment): 96 dB
Maximum sound pressure level: 130 dB music peak
Transducer complement:
18" Peavey® Pro Rider™ woofer, Model 1808-4 DPE-CP
Box Tuning Frequency:
40 Hz
Electronic Crossover
Continuously variable from 90 Hz to 180 Hz.
Low Pass slope: 24 dB/octave
High Pass Output slope: 18 dB/octave
Infrasonic Filter Slope: 36 dB/octave
Input Connections:
One combo female XLR/ 1/4" phone jack providing balanced
operation
Output Connections:
Two High Pass Outputs, independently electrically buffered.
One Full Range Thru, electrically buffered.
Electronic Input Impedance (Nominal):
Line In: 2.2 k ohms balanced (XLR or 1/4"), 10 k ohms
unbalanced 1/4"
Controls:
Level Control: Provides gain adjustment
Crossover Frequency Adjust: Adjusts electrical crossover
frequency from 90 Hz to 180 Hz, continuously variable.
Polarity Switch: Provides either 0 degrees or 180 degrees sub
woofer phase
Ground Lift Switch for input.
Enclosure materials and finish:
18 mm plywood with internal bracing, and with textured black
acrylic paint finish.
Perforated full-length steel grille with black powder coat finish.
Mounting Provisions:
1 3/8” threaded pole mount with M20 threaded pole for stand
mounting a suitable speaker on top of the Sub, and four large
rubber feet on bottom for floor use.
Dimensions:
H x W x D
26.38” (67.0 cm) x 22.88” (58.1 cm) x 24.56” (62.4 cm)
Weight: 86 lbs. (39.1 kg)
Power Requirements of Peavey DPE 118P System:
Nominal 700 watts
Operating voltage:
100 - 120VAC 50/60 Hz (domestic)
220 - 240VAC 50/60 Hz (export)
All power measurements made at 120 VAC and 240 VAC.
*Specifications subject to change without notice