Pearl VX5WV, Руководство владельца/оператора

Страница: 12 / 16

– 12 –
x. CARE AND MAINTENANCE
For your safety before performing any maintenance on the saw turn off the power switch
and unplug the power cord.
WARNING!
GENERAL RULES
• Always clean the machine before performing any
maintenance/ repair.
• Before performing any cleaning/maintenance
/repair, the machine must be switched off with the
main power switch.
Steps to Follow When Cleaning:
• Please do not use aggressive cleaners (i.e.
containing solvents). Do not use high-pressure
water jets, aggressive detergents or solutions and
liquids with a temperature exceeding 86ºF! Use a
fluff-free cloth only.
• Use a cloth which may be lightly moistened only for
removing dust and dirt. Hard packed dirt can be
removed with a soft brush.
• For the sake of safety, no water/cleaning
liquid/vapor may penetrate into the electric motor,
connectors/plugs, switches, etc. Therefore cover
all apertures, holes in the housing, connectors or
plugs, etc. or seal them with adhesive tape!
• Use a soft, low-pressure water jet and a brush to
rinse dirt and incrustations away. Be particularly
careful when near hazardous parts of the machine
(e.g. switch, motor). Clean the motor and switches
only by wiping with a moist cloth.
• Do not “rinse” the bearings of the drive elements to
prevent them from running dry. The ball bearings
of the machine are permanently lubricated.
• After cleaning, remove all covers and adhesive
tape! All screws/nuts which you may have
loosened must be tightened again!
• After wet cleaning, try the machine on a power
outlet which is equipped with a power breaker (i.e.
fault current circuit breaker). If the fault current
circuit breaker cuts the power supply, the machine
must be inspected by an authorized dealer prior to
use!
CLEANING
1. Use a slightly moist cloth to clean the surface of
the power tool after every use. Hard packed dirt
can be removed with a soft brush.
2. Blow dirt out of the air vent after every week of
use.
3. Clean the surface using a slightyly moist cloth.
Hard packed dirt can be removed with a soft
brush the pump, or replace if necessary.
CARBON BRUSH REPLACEMENT
1. Remove the motor fan cover (see fig. 11).
2. Locate the carbon brush cap. Remove the caps
(turning counter-clockwise) to access the
brushes (2).
3. Remove the brushes.
4. When installing the new brushes, make sure they
fit snugly into the slots. Do not modify the
replacement brushes (i.e. file them down) or use
non OEM brushes, as it may damage the
armature and in doing so voids the manufacturer
warranty.
5. Replace the carbon brush caps.
6. Reassemble the motor fan cover.
Figure 11