– 7 –
–
1. Remove the water pump from the box and
check that it is not damaged.
2. Place the pump within the water tray such that
the water outlet is horizontal.
See Figure 2.
3. Connect the water hose from the blade guard to
the pump and plug the pump’s power cord into
the female plug that is attached to the post.
4. Fill the water tray so that the water intake is fully
immersed. Proper water level must be
maintained at all times during saw operation.
WARNING: Disconnect the pump before
attempting to handle the pump. Never
operate pump without water in the tray.
1. The ruler guide has inches marked along the
top to allow convenient measurements and to
promote precision cuts.
See Figure 3.
2. The cast aluminum cutting table spans an area
of 14-1/2" x 14", which allows it to provide
greater support for handling larger materials.
3. A rip guide should be used together with the
cutting table to ensure precision while making
cuts.
1. Set the rip guide at the desired location on the
ruler guide and tighten the threaded knob.
Make sure that the rip guide is firmly tightened
to avoid slippage. The rip guide can be used for
45º and 90º cuts from both the left and right
side.
2. After the rip guide is positioned for the desired
cut, place material flat against the rip guide and
the ruler guide.
3. Now you are ready to make your cut.
1. Remove threaded knob from the end of the rip
guide with the horizontal groove and insert it
into the other end with the diagonal grooves.
2. Position the rip guide along either of the
diagonal premarked lines that intersect the
ruler guide and the vertical channel of the
cutting table. Tighten threaded knob once in
place.
3. Place one corner of the material being cut in the
vertical slot of the ruler guide and rest the
adjoining edge flat against the rip guide.
4. Now you are ready to make your cut.
To make miter cuts, an optional miter block must
be purchased.
1. Place the lip of the miter block on the ruler
guide with the threaded knob facing you.
2. Position the miter block such that a tile laying
flat against the block may rest its left-most
edge within the vertical channel of the cutting
table. Tighten the threaded knob to secure the
miter block in place.
3. Place material onto miter block and you are
ready to cut.
Figure 2
Figure 3
WATER PUMP INSTALLATION
USING THE RIP GUIDE
PERFORMING DIAGONAL CUTS
PERFORMING MITER CUTS
USING THE CUTTING TABLE
