– 18 –
xiv. ACCESSORIES AND PARTS
Name (Qty.)
Stainless Steel Water Tray (1)
Drain plug not included
Part Number
PA00072
Name (Qty.)
Optional Universal
Saw Stand (1)
Part Number
V35010-UV
Name (Qty.)
Optional Complete
Miter Block with
Knob (1)
Part Number
S1000-34
Knob Only (1)
V35016
Knob Only (1)
V35016
xiii. TROUBLESHOOTING
For your safety and the safety of others, turn the power switch off and always remove the plug from
power source before troubleshooting. Repairs performed by unauthorized personnel could cause serious hazard. We
recommend that service to this tool be performed by a qualified service technician with original equipment replacement parts.
WARNING!
EXCESSIVE NOISE.
Possible blade shaft bearing wear,
motor belt loose or motor fan rubbing on housing. Have
tool serviced.
BLADE WILL NOT CUT.
Check for worn out diamond edge.
Be sure that the arrow on the blade is rotating the same
direction as the motor arbor and/or arrow on the blade
guard. Make sure the blade is suitable for the material to be
cut. If blade has been used to cut a material that is hard, it
may have become dull, dress the blade by cutting a light
weight abrasive building block to expose fresh diamonds.
Blade dressing stones are available from your local Pearl
Warehouse.
MOTOR WILL NOT START.
Check power supply. If the
water pump turns on when the power switch is in the “on”
position, but the motor does not, have the motor serviced.
MOTOR WILL NOT STOP.
The contacts in the switch may
have become arched together in the on position, have it
serviced.
MOTOR SHUTS OFF DURING OPERATION.
Check to see
that the circuit you are using is not overloaded with lights
or other equipment. The fuse or circuit breaker may not
have sufficient capacity, use 20-amp power. If you are
using an extension cord check the extension cord table to
be sure it is heavy enough to carry the current this product
will draw.
See Page 14
for electric cord reference.
EXCESSIVE VIBRATION
Check to see that the blade is
mounted properly according to safe operating practices
section. Blade may be out of balance, try a different blade.
Arbor shaft bearings possibly worn, have tool serviced.
NOT CUTTING SQUARE.
Check the main table and carriage
adjustment as well as the blade alignment procedure
located in the care and maintenance section.
MAIN TABLE DOES NOT MOVE FREELY.
Inspect the guide
rails and rollers for build up of tile chips or dry slurry
deposits. Clean and check guide roll or adjustments,
according to the procedure in the care and maintenance
section.
NO WATER FLOW TO BLADE.
Check the water feed tube for
kinks or obstructions. Check the inlet screen to ensure it is
not clogged. Remove the pump inlet and turn the impeller
to ensure it is not damaged or jammed. Clean the impeller
if necessary and apply a drop of light oil to the shaft - be
sure the impeller spins freely.
POOR MACHINE PERFORMANCE WITH LITTLE POWER.
Check cord/extension cable for appropriate length and gage.
Check power network for sufficient power and circuit
breaker capacity.
CENTER HOLE IN BLADE OVERSIZE OR WORN.
Saw blade
has slipped on shaft while running. Check shaft for damage
and replace blade.
Name (Qty.)
Complete 45˚/90˚
Rip Guide with
Knob (1)
Part Number
V35000
Name (Qty.)
GFCI (1)
Part Number
V305018-REV
Name (Qty.)
Extension Cord (1)
Part Number
V35019
