- 9 -
- 10 -
ASSEMBLYING THE TRU-TRAC BASS DRUMHEAD
1. Unscrew the bolts on the Tru-Trac Bass Drumhead
using the provided Hex wrench and remove the black
steel hoop (Fig. 9).
2. Turn the Tru-Trac Bass Drumhead over and place it on
your hand (Fig. 10).
3. Place the Bass Drum Head over the Tru-Trac Bass
Drumhead as shown making sure that the Guide Posts
on the Tru-Trac Bass Drumhead are inserted into the
corresponding guide holes in the Bass Drum Head
(Fig. 10-A & 10-B).
4. Place the black steel hoop as shown making sure that
the Guide Posts on the Tru-Trac Bass Drumhead are
inserted into the corresponding guide holes in the
black steel hoop (Fig. 10 & 10-B).
5. Hand tighten the bolts on the Tru-Trac Bass Drumhead
from underneath.
6. Turn the Bass Drum Head over and tighten the bolts
securely using the provided Hex wrench.
ASSEMBLYING THE BASS DRUM
Note
*The Bass Drum Head will be floppy at this point but will
become taut when attached to the shell and tightened.
1. Place the Front Head on to the Bass Drum shell as
shown with the Pearl logo up and square the Pearl logo
(Fig. 11). Place the Bass Drum hoop over the head with
the flat side of the hoop facing down (Fig. 11-A). Hook
a Tension Rod and Claw on the Hoop above each lug
and tighten the Tension Rods using the provided Drum
Key.
2. Turn the drum over and put the Bass Drum Cushion
inside and at the bottom the Bass Drum Shell. Make
sure that the Cushion doesn't touch the Jack Box
inside the shell
(Fig. 12).
3. Insert the “L” shaped end of the Jack Box Cable into
the Tru-Trac Bass Drumhead as shown (Fig. 13-A) and
insert the other end of the cable into the Jack Box
inside the Bass Drum shell as shown (Fig. 13-A).
4. Place the Batter Side Head onto the Bass Drum shell
with the Tru-Trac Bass Drumhead facing the top of the
Bass Drum as shown (Fig. 14). Place the Bass Drum
Hoop over the head with the flat side of the hoop
facing down (Fig. 14-A).
5. Hook a Tension Rod and Claw on the Hoop above
each lug and tighten the Tension Rods using the
provided Drum Key (Fig. 14-A).
6. Attach the Hoop Protector on the batter side hoop
where you attach your pedal.
Fig.9
Fig.12
Fig.11
Fig.11-A
Fig.13-A
Fig.13
Fig.14
Fig.10
Fig.10-B
Top
Bottom
Fig.10-A
Bolt
Bass Drum Cushion
Jack Box Cable
Head
Tesion Rod
Hoop
Claw
Tesion Bolt
Hoop Protector
Hoop
Claw
Washer
Bolt
Guide
Post
Washer
Tru-Trac
Bass Drumhead
Tru-Trac
Bass Drumhead
Black Steel
Hoop
Tru-Trac
Bass Drumhead
Guide Post
Guide Post
Bass Drum Head
Black Steel
Hoop
Black Steel
Hoop
Jack Box
Claw
Hoop
Fig.14-A
Claw
Hoop
sample
