– 7 –
–
THE CUTTING TABLE
The heavy-duty cutting table provides the durability to
handle large materials.
Figure 3.
STEPS TO USE THE 45˚ / 90˚ RIP
GUIDE
1. Set the rip guide by positioning it on the
desired dimension and tighten the threaded
knob. Make sure that the rip guide is firmly
tightened to avoid slippage. The rip guide can
be used 90˚ rip cugts and 45˚ angle cuts from
both the left and right side. (Note: The
straight and 45˚ angled slits on the bottom of
the rip guide.)
2. After the rip guide is positioned for the
desired cut, place material flat against the rip
guide and the measurement rail. For the 45˚
rip cuts, place the corner of material in the
open slot of the measurement rail.
3. Simply line up the material being cut with the
appropriate pre-marked lines on the cutting
table.
4. Now you are ready to make your cut.
CUTTING DEPTH
The recommended cutting depth is 1/4" below the
cutting table surface. When setting the cutting depth,
do a practice pass with the table to make sure the
blade does not cut into it.
The VX141MSPROR Masonry Saw is designed to cut
at any cutting. It can perform plunge cutting (table is
fixed and the cutting head is in motion), jam cutting
(cutting head is fixed and the table is in motion) or
step cutting (a combination of the both).
1. Before adjusting the cutting depth always
disconnect the electrical power supply.
2. To adjust the VX141MSPROR's cutting depth,
rotate the depth control knob counter-
clockwise while holding the plunge handle
See Figure 4
. Only loosen the knob enough so
the cutting head freely moves.
3. Reposition the cutting head as necessary and
then lock it in place by rotating the knob in the
reverse direction. Tighten the knob firmly.
CHOP / PLUNGE SAW
OPERATION
To operate the VX141MSPROR as a chop or plunge
saw: pull up on the Angle Lock Pin, rotate 90 degrees,
and release. Now the cutting head can be rotated by
pulling up or pushing down on the cutting head
handle. When not in use, always lock the head into
one of the three cutting height positions.
WARNING: Only use the 14” diameter blade
for this saw. Setting smaller size of diamond blade
may grab the material being cut, causing damage
and possibly injury.
WARNING: It is recommended to cut all the
way through the material being cut. Failure to do
so can result in the diamond blade grabbing the
material causing damage and possibly injury.
Figure 3
Blade Diameter Cutting Depth
14" 5 inch
HEAD POSITION APPLICATION
Fixed head Jam cutting brick/block
Fixed head upper Diamond blade replacement
Moving head Chop or plunge cutting
Moving head with Step cutting
moving table
Figure 4
