4
4) Report any shipping damaged to the shipping carrier’s agent.
2. Preparation for use
1) Before tuning the unit on verify that the AC line is within 85 V to 270 V AC (
±
10%), at a line
frequency of 48 to 66 Hz.
2) Check to see if the fuse has the correct rating. (T2AL / 250 V)
3) Make sure the unit is connected properly and is being used within the specifications listed above.
3. Environmental
1) This equipment should be operated in a well-ventilated area, with in a temperature range of 0 to
+40°C (+32°F to 104°F) and a relative humidity 85% or less and stored in a dry place within
temperature range between -20°C to +70°C (-4°F to +158°F) with a relative humidity 85% less.
Chapter 3. Product description
In this chapter, the front and rear panel buttons, controls and connectors are described.
1. Front Panel buttons and connectors description
Programmable Function Generator
[Figure-1] Front Panel
1)
VCF
input terminal
An external voltage applied to this input causes the frequency to deviate. A + 5 Voltage applied to
the input causes a maximum frequency deviation and a –5 Volts a minimum frequency deviation.
The maximum deviation is 100:1 which is useful for external sweep and FM modulation.
2)
TTL
output terminal
A TTL signal level with the same frequency as displayed on the LCD is available from this terminal.
3)
FUNC
output terminal
The output waveform with the characteristics (amplitude, offset, etc) as displayed on the LCD is
available from this terminal
PeakTech
®
1015 GPIB
