Peak SML-2500, Инструкция по установке и обслуживанию

Страница: 27 / 35

25
VI. OPERATION INSTRUCTIONS
To lift vehicle
1. Keep clean of site near the lift;
2. Position lift arms to the lowest position;
3. To shortest lift arms;
4. Open lift arms;
5. Position vehicle beside of the lifting arm, cab should at the other side of the column;
6. Move arms to the vehicle’s lifting point;
Note: The four lift arms must at the same time contact the vehicle’s lifting point
where manufacturers recommended
7. Turn on the power QS1 and push the button , raise the lift until the rubber pad
full contact the car and ensure it’s safe.
8. Continue raise the vehicle to the desired height and make sure the vehicle is steady
when the lift is rising, then release the “ Up ” button.
9. Press the button DOWN to low down the lift onto the safety lock. Confirm the
safety device at normal working condition, then the vehicle is ready to repair.
To lower vehicle
1. Be sure the clearance of around and under the lift, only leaving operator in lift area;
2. Push button “
UP” to raise the vehicle slightly, and then release the safety device,
lower vehicle by pushing the down button; stop lowering when above ground 300mm,at
this moment should push button ”K” at side, then buzzer will ring and lift lower to ground.
3. Open the arms and position them to the shortest length;
4. Drive away the vehicle.