Peak PCAN-USB Pro, Руководство пользователя

Страница: 12 / 44

PCAN-USB Pro – User Manual
12
When using this option the 5-Volt supply is connected to the power
supply of the computer and is not fused separately. A DC/DC con-
verter is interconnected. Therefore the current output is limited to
50 mA.
Tip: On request we deliver the device configured with this
option.
Proceed as follows to activate the 5-Volt supply:
Remove the three screws at the back of the aluminum casing, take
off the cover plate and pull the PCB out of the lower part of the
casing.
Set the solder bridge(s) on the PCB of the PCAN-USB Pro adapter
according to the desired function. During this procedure take espe-
cially care not to produce unwanted short circuits on the board.
The following figure shows the positions of the solder fields on the
PCB of the PCAN-USB Pro adapter; the table below contains the
possible settings.
Figure 4: Positions of the solder fields L3 and L22
on the bottom side of the PCB of the PCAN-USB Pro adapter