PCAN-Router Pro – User Manual
11
The D-Sub connectors have pins with additional functions:
Connectors
Pin Function
CAN 1, CAN 2,
CAN 3, CAN 4
1
5-Volt supply for external devices (to be
activated on the circuit board)
CAN 3, CAN 4 4
Input for external wake-up signal
CAN 3, CAN 4 9
Supply of the router via a D-Sub
connector (to be activated on the circuit
board)
Note:
The additional functions at the D-Sub connectors are not
galvanically isolated. When using the transceiver module
PCAN-Transceiver MAX3057-ISO, galvanic isolation is only
provided for those pins that are assigned to CAN
communication at the corresponding D-Sub connector
(2: CAN_L, 7: CAN_H, 3: CAN_GND).
2.3
CompactFlash Card
To log the CAN data traffic (trace) you can use CompactFlash cards
(CF cards) with a maximum capacity of 2 GByte.
The CF slot is located on the rear of the PCAN-Router Pro. The CF
card is properly inserted if it flushes with the rear panel.
Note:
When you want to insert or eject a CompactFlash card,
the PCAN-Router Pro must be turned off (no power supply or
power-down mode, Power LED off). Else the card is not
detected or data gets lost.
About the use of a CF card see chapter 6