BASIC OPERATION
Please refer to a text that appears as under switches when you are going to use the FCB4N unit in the basic
operation mode. On power up, the latest preset is selected and transmitted MIDI message via MIDI out.
(Initial value is Bank#1, preset#1 of mode F1)
You can not program or set any changes on a preset when you are working on an operation mode because
we design the firmware to have no delay when the FCB4N transmitted MIDI messages via a MIDI out. The
MIDI messages are suddenly transmitted once the selected preset is pressing.
Bank and Preset selection
In each mode has different total bank on the function but has 32 Banks maximum. (Bank#1 – Bank#32)
Press
BANK UP
or
BANK DOWN
switches to move/scroll from the current bank to another. The
BANK/PROGRAM
display will flash and has no MIDI message transmitted until a preset switch is selected.
(P1
, P2, P3
or
P4
switches) You can hold on the
BANK UP
or
BANK DOWN
switches to/past the current
bank continuous and the
BANK/PROGRAM
display will be looping once it is out of limit.
You can selected a preset by press the
P1, P2, P3
or
P4
switches then the selected preset LED above the
switch will be on with MIDI message suddenly transmitted.
SETUP MODE AND PRESET PROGRAMMING
When you supplied power into the FCB4N unit then it is going to launch operation mode automatically. You
can not program or setting on this operating mode. You should tell the unit knows that you want to setting
or programming. This chapter is explain how to programming or setting the FCB4N
Programming Mode Enable
You have to enable the programming mode every time when you need to setting/programming on a FCB4N.
You can enable the programming mode by step following
1.
Remove power from the FCB4N unit.
2.
Press
P1
switch and hold on.
3.
Plug the power into the FCB4N unit.
4.
The
BANK/PROGRAM
display will show as characters below
5.
The
BANK/PROGRAM
display as characters above is meaning
“Programming Mode Enable”
then release the
P1
switch.
6.
The FCB4N will be initializing with programming mode enable so, you can program the unit
follow by the next chapters.
7.
You can disable the preset programming mode by simply remove the power plug out from a
unit.