background image

1. DOOR PREPARATION

 

Prepare the door for the mortise lock.

Generic template in box, function specific templates 
located at www.pdqlocks.com

 

Install the mortise case and secure using two (2) #12-24 
combo screws supplied in the hardware kit.

2. JAMB PREPARATION

 

Prepare the jamb for the mortise lock strike.   

 

Install Dead Latch Plate behind strike with slider toward bottom for 
dead latch.

 

Install the strike and secure with two (2) #12-24 combo screws 
supplied in the 

strike screw pack

.

Dead Latch 
Slider

MR – MORTISE LOCK F-TYPE ESCUTCHEON TRIM

INSTALLATION INSTRUCTION

Phone: 833-2-PDQTEC | www.pdqlocks.com

3. ESCUTCHEON TRIM HANDING

NOTE: The trim is handed as labeled from the factory.

OUTSIDE TRIM

 

Pull out on the spindle until it stops and hold.

 

While holding the spindle and escutcheon rotate the lever to the
new operating position.

 

Raise the lever to 60° above horizontal and hold.

 

Release the spindle and apply light pressure on the end the spindle.

 

Lower the lever to the horizontal operating position.
   - As the lever is lowered the spindle will re-engage with the lever.
   - Verify this by rotating the lever down from horizontal.
   - The springs in the assembly will compress as the lever is rotated.

INSIDE TRIM

 

Remove the lever.

 

Orient the escutcheon as it will be installed on the interior face of the door.

 

Rotate the top outside corner of the sqaure spindle toward the hinge side of 
the door.
   - RH and RHR doors, rotate the spindle CCW (counter clockwise)
   - LH and LHR doors, rotate the spindle CW (clockwise)

4. INSTALL TRIM

OUTSIDE TRIM

 

Install escutcheon to door while aligning the spindle with the 
lock hub.

 

Confirm the spindle engagement in the lock by rotating the 
lever down and verifying that the latchbolt retracts.

INSIDE TRIM

 

Install escutcheon to door while aligning spindle with the lock 
hub.

 

Confirm the spindle engagement with the lock by rotating the 
lever down and verifying that the latchbolt retracts.

 

Secure the trim assemblies with two (2) #10-24 oval head 
screws from the inside of the door.

6. INSTALL ARMOR PLATE

 

Install the armor plate with two (2) stainless steel #8-32 x 1/4" 

flat head machine screws.

W53053 Rev0 – 11/20/19

5. INSTALL CYLINDER

 

Install cylinder and adjust, making it flush or slightly recessed 
into the escutcheon

For I/C housings, install the slotted set screw through the I/C 
bore to secure the housing.

 

Secure the cylinder by tightening the cylinder set screw 
through the front of the case with the supplied 2.5mm hex key.

Does not apply to I/C when using slotted set screw.

Cylinder Set
Screw – 
Tighten 
side(s) with 
cylinder

Отзывы: