1. DOOR PREPARATION
Prepare the door for the mortise lock.
Generic template in box, function specific templates
located at www.pdqlocks.com
Install the mortise case and secure using two (2) #12-24
combo screws supplied in the hardware kit.
2. JAMB PREPARATION
Prepare the jamb for the mortise lock strike.
Install Dead Latch Plate behind strike with slider toward bottom for
dead latch.
Install the strike and secure with two (2) #12-24 combo screws
supplied in the
strike screw pack
.
Dead Latch
Slider
MR – MORTISE LOCK F-TYPE SECTIONAL TRIM
INSTALLATION INSTRUCTION
Phone: 833-2-PDQTEC | www.pdqlocks.com
3. SECTIONAL TRIM HANDING
NOTE: The trim is handed as labeled from the factory.
OUTSIDE TRIM
Pull out on the spindle out of the lever and hold.
Note: The spindle is captured and will not be completely
removed from the trim assembly.
While holding the spindle and rose plate rotate the lever to the new operating
position.
Raise the lever to 60° above horizontal and hold.
Release the spindle and apply light pressure on the end of the spindle.
Lower the lever to the horizontal operating position.
- As the lever is lowered the spindle will re-engage with the lever
- Verify this by rotating the lever down from horizontal.
- The springs in the assembly will compress as the lever is rotated.
INSIDE TRIM
Remove the lever and rose scalp.
Orient the rose plate as it will be installed on the door and hold.
Note: The thru-bolt holes will be at 12 o'clock and 6 o'clock
- The rose plate does not have a top or a bottom.
Rotate the square spindle toward the hinge side of the door.
- RH and RHR doors, rotate the spindle CCW, counter clockwise.
- LH and LHR doors, rotate the spindle CW, clockwise.
6. INSTALL ARMOR PLATE
Install the armor plate with two (2) stainless steel #8-32 x 1/4"
flat head machine screws.
W53053 Rev0 – 11/20/19
5. INSTALL CYLINDER / THUMB TURN
CYLINDER
Install cylinder and adjust, making it flush or slightly recessed
into the escutcheon
For I/C housings, install the slotted set screw through the I/C
bore to secure the housing.
Secure the cylinder by tightening the cylinder set screw
through the front of the case with the supplied 2.5mm hex key.
Does not apply to I/C when using slotted set screw.
THUMB TURN
Insert the thumb turn.
Secure the thumb turn with two (2) #6 truss head screws
supplied in the screw pack.
Cylinder Set
Screw –
Tighten
side(s) with
cylinder
Lever
Spindle
OUTSIDE TRIM
Rose
Plate
4. INSTALL SECTIONAL TRIM / ROSE
OUTSIDE TRIM
Install rose to door while aligning the spindle with the lock hub.
Confirm the spindle engagement in the lock by rotating the
lever down and verifying that the latch retracts.
INSIDE TRIM
Install the inside rose assembly to the inside of the door. Align
the spindle with the lever.
Secure inside rose assembly with #10-24x1-1/2" flat head
machine screws, supplied in the hardware kit, Confirm the
spindle engagement.
Install the rose scalp by aligning the dimples with the slots in
the rose plate. Secure by rotating clockwise until tight.
Set Screw
Rose
Plate
Rose
Spindle
INSIDE TRIM
Spindle
