Pinnacle IKONIC Slimline DKL067, Руководство пользователя

Страница: 1 / 4

Slimline Combination Entrance Set
Step 1: Preparation
Cut template on line (A) & fold on line (B)
as shown. Place on door at your preferred
height and mark both the latch height
(C) and centre of handle hole (D) with a
pencil. Remove template, and measure
the thickness of door to mark the centre
point of the door edge. Use a 25mm
spade bit to drill an accurate hole through
the door edge, and using a hole saw, drill
a 54mm hole through the door front.
Accuracy is vital so mark and measure
carefully and drill holes level.
Step 2: Installing the Latch
Place Latch (E) into the 25mm hole
on the side of the door and mark
the door around the square plate
with a pencil. Using a hammer and
a chisel check out the timber so
that the latch fits into the newly
created recess and finishes flush
with door. Once completed push
latch into place and drill 2mm pilot
holes into the door edge, simply
use screwdriver to insert the timber
screws included.
Instructions to install this Slimline entrance lever set
If installing this entrance set into a new door you will need the following tools - 25mm spade bit, 2mm drill bit, 54mm hole saw, corded or cordless drill, hammer, wood chisel,
Phillips head screwdriver, tape and pencil. If you are replacing an existing lever you shouldn’t require the drill, hole saw or spade bit as this lever will replace most standard levers.
Very Important!
This Slimline entrance lever set is designed to suit either left or right hand opening doors.
Please fasten all screws by hand and not an electric screw driver or drill, as over tightening is not recommended.
Step 3: Attaching the levers to door.
Insert the lever handle with spindle (F) through the door
hole and into the latch (E). Now insert the two screws (K)
through from inside the room and tighten firmly.
How to convert latch from 60mm to 70mm
Slide tab from the marked 60mm position to the 70mm position.
Line B
Line A
C
D
60mm
(or 70m
m)
Tip: Before closing the door,
check that the operation of the
handle functions correctly.
Move tab from
60mm to 70mm