Controller button manual
BUTTON
NUMBER OF BUTTON PRESSES
FUNCTION
ON/OFF
CHANGE CHANNEL
START/STOP RECORDING
TURN ON/OFF
CALIBRATION THE LENS
A - B POINT LIMIT
CHANGE CONTROL CHANNEL
CHANGE THE ZOOM / IRIS SPEED
CHANGE THE MOTOR DIRECTION
7. Adjust the speed
Before using the focus of the controller to control the handwheel and the push-pull Lever on both sides, please check
whether the motors in the corresponding control channels can be used normally. Short press the ZOOM/IRIS button of
the controller 5 times to cycle through the three-speed control speed of the ZOOM/IRIS push-pull rod (FOCUS cannot
adjust the speed, the default is the fastest). Short press the button at the bottom of the motor 5 times to switch the
motor speed cyclically. In addition, the rotational speed and direction of the motor can be adjusted by the controller or
the motor.
BLUETOOTH PAIRING
①
③
④
⑤
⑥
⑦
⑧
⑨
⑩
②
Long press 3 seconds
Short press 1 time
Short press 2 times
Short press 3 times and long press 3 seconds
Long press 3 seconds
Short press 1 time
Short press 2 times
Short press 3 times
Short press 5 times
Short press 7 times
③
Start/stop recording
：
This function requires additional purchase of video cables of different models of cameras to use.
⑨
Change the speed
：
This function only supports adjusting the two push-pull rod parts of ZOOM and IRIS.Because the Focus
handwheel defaults to the fastest speed, it cannot be changed
*More features
，
See the table below
FOCUS
IRIS
ZOO
M
The default is the fastest, the
indicator light is always on
（
Not adjustable
）
Blinking Fast = Fast Speed
Blinking Slow = Medium Speed
Always On = Slow Speed
(
Short press the button for 5 cycles to adjust
)
Blinking Fast = Fast Speed
Blinking Slow = Medium Speed
Always On = Slow Speed
(
Short press the button for 5 cycles to adjust
)
Blinking Fast = Fast Speed
Blinking Slow = Medium Speed
Always On = Slow Speed
(
Short press the button for 5 cycles to adjust
)
*When the controller and the motor are in the same signal channel and control channel, and the lens is
automatically calibrated, it can be used.
ZOOM IRIS CONTROL CHANNEL EXCHANGE
8