PDMOVIE PD4-S1, Руководство по эксплуатации продукта, Страница: 6 / 12

1.Install the motor
on (15/19mm) rods
2.Locking U-clamp
3.Install the Antenna
and the Power Cable
1. Install the Motor
Install the motor on the 19mm or 15mm conduit (requires an adapter ring), pay attention to clamp the
motor gear and lens gear, then lock the U clip, and finally install the antenna and power cable or
serial cable on the receiver motor (PD-RP).
Instruction Manual Install
2. Wiring
PD4-S1

Single Channel

：
Connect the power cable to the PD-RP (receiver motor) and the battery
with the D/P-tap socket.
PD4-S2(Double Channel)
：
First connect PD-RP and PD-MX (slave motor) with serial cable, then
connect PD-MX and battery (with D/P-tap socket) with power cable.
PD4-S3

Three Channel

：
First use two serial cables to complete the connection between PD-RP
and two PD-MX, and finally use power cable to connect PD-MX and battery (with D/P-tap socket)
*
The REMOTE 7-20V sockets on the PD-RP and PD-MX have the same function are used for power and
signal transmission.
D-Tap Power Cable
PD-RP
( Receiver Motor 뻜
PD-MX
뻛 Slave Motor 뻜
PD-MX
뻛 Slave Motor 뻜
Serial Cable
Serial Cable
5