Instruction Manuals
Set Up
Motor button
Controller button
Alternate channel
Alternate channel
Alternate channel
IRIS
ZOOM
FOCUS
Control
Purple
Cyan
Yellow
BLUE
GREEN
RED
Indicator color
P6
C5
Y4
B3
G2
R1
Channel
Short press 2 times
Short press 2 times
Short press 3 times
Method 2
: Press and hold the the motor button for three seconds until the motor turns and release, the motor
will automatically calibrate the lens. When using multiple channels, it is necessary to operate motor by motor.
Method 3
: Manually calibrate the lens travel: After the motor powers on, make sure that the motor gear and
the lens gear are fully engaged, manually rotate the lens to the starting point and stop for 0.5 seconds, then
rotate the lens to the end point and stop for 0.5 seconds, and finally, turn the lens slightly towards the starting
point, the motor will complete the lens travel learning. (Lenses without hard stops are best for this feature)
When using multiple channels, it is necessary to operate motor by motor.
Press for
3S
6. Calibrate the lens
Method 1
: Press and hold any of the FOCUS, ZOOM and IRIS buttons on the controller for three seconds, the
motor will will automatically calibrate the lens travel. When using multiple channels, multiple motors will start
auto-calibration at the same time.
ZOOM
FOCUS
IRIS
Press any of the
three buttons for 3
seconds
7