Document Number: PD196-244R8
PD295-002
Page 16 of 28
PDi Communication Systems, Inc. 40 Greenwood Lane Springboro, Ohio 45066 USA PH 1-800-628-9870 FX 937-743-5664
Menu 6 provides STB configuration settings and firmware information.
MENU ITEM
EXPLANATION
STB Signal Input
Sets the TV’s signal type input to correspond to the STB’s signal output. The majority of STB’s
utilize modulated RF as the signal type and is the type shown in this instruction manual. TUNER is
the default setting. Additional settings are available for STB’s with different output signal types.
STB Channel
When the STB Signal Input is se
t to “Tuner”, STB Channel sets the channel the TV tunes to view
the STB’s signal. This setting should match the STB’s “CH” switch setting which is usually 3 or 4.
STB Model
Model number of Set Top Box. Must match actual unit for proper operation.
NOTE: Changing the STB Model does not change the previous STB Key selections. If the STB
Model is changed, the STB Key selections should be reviewed to determine if they are the desired
mappings for the installation.
Restore Factory
Defaults
Press vol
► to restore all interface settings, for the selected STB model, to factory defaults.
NOTE: Each STB m
odel has a unique set of Factory Defaults. Selecting “Restore Factory
Defaults” changes the parameters to the Factory Defaults for the selected STB model and it does
not change the “STB Model” selection.
The default settings for each supported STB are
detailed below in “Appendix B – STB Functions
and Default Mapping Reference”
Flash Power LED
This provides a diagnostic tool to help determine if the TV is connected to the expected STB. If
“Flash LED” is turned on, the “Power LED” on the interface module controlled by this TV will flash to
help identify the correct interface module to the expected TV.
NOTE: This is not a stored parameter. It is set to “OFF” by changing this selection or by cycling
power to the interface module.
Interface F/W Ver
PDi Set Top Box Interface Firmware Version
TV CCI Ver
CCI communication protocol version reported by TV
IR Cable
Connection status of IR Emitter cable to the interface module.
INTERFACE MODULE SETUP 6/6
STB Signal Input
Tuner
STB Channel
003
STB Model
DC50X
Restore Factory Defaults
>
Flash Power LED
Off
DIAGNOSTICS
Interface F/W Ver
V3.05
TV CCI Ver
V4.6
IR Cable
Connected
Exit: SETUP/OK Cancel: POWER
