Note 1:
-Press and hold the button until LED turns green, then starting record.
-If LED do not turns green after pressing and holding the button for a long time, please do not use this
data logger.
-This is a single use data logger, so make sure it’s correct to start.
-When recording, one of the LEDs will flash once every 3sec.
-After plug into PC, record ending
Note 2:
After the device starts recording temperature data, if the data is higher than the Upper Alert or below
than Lower Alert, red or blue lights will flash to alarm, the green light will not flash again;
if Upper Alert
and Lower Alert all happen, red and blue lights flashing always with memory function
.
