C)
Slave Zone :
This feature is good to set up when you program you system at the start. For each zone you are
using it is a good idea to give the zone the name of another zone that runs the same. For
your nozzle zones run all the same. For Nozzle 1 you would put
fails while the system is running, then this
D)
Manual Mode :
It is a good idea to put the power
will automatically switch to slave the zone or manual run the zone when the TC fails, if you have
made these settings at the beginning. During the
zone on the main screen. This will show you what
temperature.
TC50 Hot Runner Temperature Controller
-12
-
This feature is good to set up when you program you system at the start. For each zone you are
using it is a good idea to give the zone the name of another zone that runs the same. For
le zones run all the same. For Nozzle 1 you would put Nozzle 2 as the slave zone. If the TC
fails while the system is running, then this heater will follow the TC from Nozzle 2 a
It is a good idea to put the power percentage you want to run your zone
will automatically switch to slave the zone or manual run the zone when the TC fails, if you have
made these settings at the beginning. During the first run, you can watch the
zone on the main screen. This will show you what percentage the zone works at to maintain
Hot Runner Temperature Controller
This feature is good to set up when you program you system at the start. For each zone you are
using it is a good idea to give the zone the name of another zone that runs the same. For example,
ozzle 2 as the slave zone. If the TC
heater will follow the TC from Nozzle 2 automatically.
you want to run your zone if a TC fails. The controller
will automatically switch to slave the zone or manual run the zone when the TC fails, if you have
run, you can watch the percentage of each
the zone works at to maintain
