PCM SAL-DLG FIREWOR-X-TEND, Инструкция по сборке

Страница: 14 / 18

Firewor-X-tend Building instruction January 2009
9. Optimizing
In order to optimize the aerodynamical transition
between aileron and fuselage, you can glue the
aerodynamical
fences enclosed.
Ready mounted fences on Firewor-X-tend.
In order to move the triangular ends of the ailerons, you can
bend a piece of
steel wire (1mm) and glue it into the end of
the aileron as shown. Let the wire jut out about 6mm. You
can bend the end of the wire to ensure not to cause damage
to the shell on the inside.
The easier way is to connect the control surfaces with
adhesive tape (see picture).
As you nearly don’t recognize a damage of the leading edge
of the wing (f.e. after hard landing), we advise to put a
strip
of adhesive tape over the leading edge .
The film is thin enough not to disturb the aerodynamic, but it
surely will extend the lifetime of your Firewor-X-tend.
Cover the screws with a piece of tape in order to improve
aerodynamics.
Cover
the gap behind the rear screw either also with tape
… (as you see it here with Fireworks 4 carbon lite)
…or with the little carbon tile enclosed. Glue it on the part of the fuselage that is placed between
the two ailerons.
www.pcm.at
14